May 4, 2023, 3:32 p.m. | Shawn Knight

TechSpot www.techspot.com


The DIYer shared a timelapse of the design, print, and installation process over on YouTube. SolidWorks was used to create the design, which was then loaded into a Creality Ender 3 S1 3D printer. A power failure mid-print threatened to ruin the job but SamoesA DIY was able to resume...

Read Entire Article

3d printer cooling design diy failure fans gpu job power process shows youtube

Founding AI Engineer, Agents

@ Occam AI | New York

AI Engineer Intern, Agents

@ Occam AI | US

AI Research Scientist

@ Vara | Berlin, Germany and Remote

Data Architect

@ University of Texas at Austin | Austin, TX

Data ETL Engineer

@ University of Texas at Austin | Austin, TX

Codec Avatars Research Engineer

@ Meta | Pittsburgh, PA